Published By: SecurityFocus Posted By: Eric Lubow 8/15/2002
The IP Security Protocol (IPsec) and the Internet Key Exchange (IKE) protocol are designed to permit system and network administrators the capability to protect traffic between two systems. These systems can be network devices or individual hosts. With the release of Solaris 8, Sun added the ability to configure IPsec on Solaris hosts in order to construct a virtual private network (VPN) between the systems or to secure the traffic destined for a system. This article is the first of a three-part series that will examine IPsec and the key management protocol, IKE, and provide readers with an introduction on how to configure both protocols on a Solaris host.
Before delving into how to configure IPsec and IKE on a Solaris host it is helpful to understand how IPsec and IKE came into being, as well as how the two systems work.
In the mid-1980s network designers began to realize that the 32-bit address space provided by IPv4 was insufficient. As a result of this realization, the IETF, in the early 1990s, decided to design a new version of IP, IPv6, to replace IPv4. One of the key features of IPv6 was additional security at the network layer. The designers of IPv6 had the benefit of experience with IPv4, which was created with no security in mind. IPv6 would provide the capability to secure the communications between multiple hosts. This became known as IP Security or IPsec. Initially the IPv6 designers wanted to prohibit the back-porting of IPv6 features to IPv4 as a way of encouraging users to migrate to the new protocol. The designers of IPsec, however, did not care whether IPsec was deployed in an IPv4 or an IPv6 environment and therefore designed the security protocol to work in either.
News: Network Security
