AirPi: air quality station with the Raspberry Pi and the PM5003 sensor

https://www.rigacci.org/wiki/doku.php/doc/appunti/hardware/raspberrypi_air

A monitoring station for air quality based on the Raspberry Pi

pms5003

The lib/pms5003 is a Python script to read data from the PMS5003 particulate matter sensor by Plantower. It uses the serial line. It is rather complicated because it has all the following features:

• Handle sleep-down and awake of the sensor.
• Wait some time before read, allow the sensor to settle.
• Multiple read with average calculation.
• Verify data checksum.
• Handle communication errors.
• Single read or endless loop.
• Write data to status file (STATUS_FILE).
• Log to stdout/file/syslog.

The Single Read Mode is suitable for a cronjob: set AVERAGE_READS_SLEEP to -1. The sensor will be awakened before the reading, and it will be put at sleep before program exit.

For the Endless Loop Mode set AVERAGE_READS_SLEEP to the acquiring interval (seconds). If the interval is greather than three times the sensor's settling time, the sensor will be put to sleep before the next read.